Epson RC+ 7.0 Manual page 13

WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
Part Feeding 7.0 Hopper & Hopper Controller Rev.5
Build a safety system that shuts off the Hopper power when the
machine or mechanical system protection enclosure is opened.
Attach protective equipment* to the power supply line to the
hopper controller.
*: fuse, shutting down equipment for wires (MCCB), etc.
When removing hopper from the machine or machine system,
after unplugging the main power plug of the machine or machine
system, and disconnect cable connection between hopper and
hopper controller, remove the hopper.
Carry out inspections and maintenance considering safety.
Before detaching protective equipment* of the machine or
machine system, unplug the main power plug of the machine or
machine system, and turn off the power.
*: fuse, shutting down equipment for wires (MCCB), etc.
When detached protective equipment* of the machine or
machine system, before turning on the power, attach protective
equipment again.
*: fuse, shutting down equipment for wires (MCCB), etc.
Before assembling the machine or machine system, adjusting,
maintenance and repair, turn off the power by using proper power
deactivation equipment, and it must be fixed so that it does not
turn on again. If necessary, attach the sign* on the power
deactivation equipment so that it can be recognized clearly.
*: For example, "Do not turn the power on"
Be sure to comply with safety precautions of manual for the
equipment used in the machine or machine system.
- Products with 50Hz specifications cannot be used by
connecting to a 60Hz power supply.
- Products with 60Hz specifications cannot be used by
connecting to a 50Hz power supply.
2. Safety instructions
7