Information For Starting - Epson RC+ 7.0 Manual

WARNING
WARNING
WARNING
WARNING
WARNING
WARNING

3. Information for starting

DANGER
Only if all above mentioned questions can be answered with yes, the control unit can be put
into operation.
Part Feeding 7.0 Hopper & Hopper Controller Rev.5
Before detaching protective equipment* of the machine or
machine system, unplug the main power plug of the machine
or machine system, and turn off the power.
*: fuse, shutting down equipment for wires (MCCB), etc.
When detached protective equipment* of the machine or
machine system, before turning on the power, attach
protective equipment again.
*: fuse, shutting down equipment for wires (MCCB), etc.
Before assembling the machine or machine system, adjusting,
maintenance and repair, turn off the power by using proper
power deactivation equipment, and it must be fixed so that it
does not turn on again. If necessary, attach the sign* on the
power deactivation equipment so that it can be recognized
clearly.
*: For example, "Do not turn the power on"
Be sure to comply with safety precautions of manual for the
equipment used in the machine or machine system.
Products with 50Hz specifications cannot be used by
connecting to a 60Hz power supply.
Products with 60Hz specifications cannot be used by
connecting to a 50Hz power supply.
Before the mains connection is made and the control unit is
switched on, the following points must in any case be
checked:
- Is the control unit closed properly and with all screws?
- Is the existing plug fixing devices locked into place/screwed
down?
- Are all cables and ducts undamaged?
- Is the INTENDED USE guaranteed?
- Does the mains voltage indication comply with the local
power supply network?
- Does the mains frequency indication at the oscillating drive
comply with the local power supply network?
- Is the correct operating mode set at the control unit?
(on that read explanation operating mode)
3. Information for starting
25