U Mount Installation; Installing The Vc70 On A Forklift - Motorola VC70N0 Product Reference Manual

U Mount Installation

Mounting Bracket Installation
Figure 2-2
To install the U-mount:
Position the friction pads in the friction pad mounting area.
1.
Position the U-mount over the mounting holes.
2.
Place lock and flat washers onto cap screws.
3.
Screw the M12x40mm hex head screws into mounting holes and tighten. Torque the hex head screws 350 ±
4.
10% kgf-cm (300 ± 10% lbs-in).

Installing the VC70 on a Forklift

A competent engineer must perform the installation in a vehicle. Improper installation can injure the
CAUTION
operator and damage your vehicle and/or the VC70.
Follow the instructions below to properly install the VC70 on a forklift.
Installation 2 - 3
U-mount
Lock Washer
Hex Head Screw
Flat Washer
Friction Pad
Friction Pad Mounting
Area