Installing the DC Power Supply (PSU) on the VC70
NOTE Follow this procedure when using the U-mount. The PSU fastening screws are supplied with the U-mount kit.
Attach the PSU to the back of the vehicle computer.
1.
Screw the four M5x14mm screws into the PSU mounting holes and tighten. Torque the screws 20 ± 10%
2.
kgf-cm (17 ± 10% lbs-in).
Installing the PSU
Figure 2-14
NOTE When using another type of a mount to install the VC70, the PSU may have to be installed remotely. Use the
template shown below to prepare the installation surface. You need to also use an extender cable PN
25-159549-01 to connect the PSU to the vehicle computer.
Vehicle Computer
PSU
Installation 2 - 15
Fastening Screws