Sharp ER-A440 Service Manual page 72

CHAPTER 4. CHANGING EURO
FUNCTION (X2/Z2 mode JOB)
This job is own to be able to be changed easily from local currency
system to EURO currency system in X2/Z2 mode.
(Changing EURO Function)
800 X
X: 1 = EURO STATUS (B)
2 = EURO STATUS (C)
[ About EURO STATUS ]
It is executing automatically to change from status (A) to status (B) or
(C).
Selectable type is one of below 3 types.
And the selectable type is decided as below for each status.
CURRENT STATUS
↓
(A)
(B)
(C)
Marked "X" is selectable
<Selecting type and its action>
(A) to (B):
Current domestic currency (i.e. DM)
Parallel usage of actual domestic currency (EURO) and previous domestic currency
(i.e. DM)
1) Issue General Z1 report.
2) Issue General Z2 report.
3) Clear GT1/2/3.
4) Set PGM function "EX1 AMOUNT PRINTING FOR TOTAL
AND CHANGE" as "YES".
5) Set "Domestic currency symbol" as EURO SYMBOL.
(A) to (C):
Current domestic currency (i.e. DM)
Actual domestic currency (EURO) only
1) Issue General Z1 report.
2) Issue General Z2 report.
3) Clear GT1/2/3.
4) Set PGM function "EX1 AMOUNT PRINTING FOR TOTAL
AND CHANGE" as "NO".
5) Set "Domestic currency symbol" as EURO SYMBOL.
(B) to (C):
Parallel usage of actual domestic currency (EURO) and previous domestic currency
(i.e. DM)
Actual domestic currency (EURO) only
1) Issue General Z1 report.
2) Issue General Z2 report.
3) Set PGM function "EX1 AMOUNT PRINTING FOR TOTAL
AND CHANGE" as "NO".
TL
Selectable STATUS
(A) (B)
— X
— —
— —
(Caution!!)
This JOB cannot set EXCHANGE1 RATE and EXCHANGE1 CUR-
RENCY SYMBOL automatically.
EX1 RATE and EX1 CURRENCY SYMBOL must be set by PGM
mode JOB after this job.
(C)
X
X
—
4 – 1