Before Use; Put Down The Date Of First Use On The Label; Sensor Sensitivity Level Adjustment; Set Up Location - Panasonic F-P06SXY Operating Instructions Manual

Table of Contents

Advertisement

Before use

Set up location

¡ Leave a distance of at least 30 cm between the air inlet and
the wall or nearby furniture in order to allow the air in the
room circulates freely.
¡ Position the air purifier at least 1 meter away from
appliances such as TVs and radios.
¡ Do not run the air purifier from the same wall socket as a
TV or radio.
(Picture or sound interference may occur.)
¡ If the air purifier is used in the same place for a long period,
the wall surfaces around the air purifier may become dirty.
Put down the date of first
1
use on the label at the rear
of the air purifier.
¡This can be used as a guide for replacing
the composite air filter and odor filter.
Filter replacement
Dust collecting filter
Replace the filter when the filter check
lamp comes on.
(approx. five years)
Replacement filter
-
Part No.
F Y106WY
Date installed:
Deodorizing filter
Replace the filter when the deodorizing per-
formance become lessen.(approx. three years)
Replacement filter
-
Part No.
F Y506WY
Date installed:
Removing the front panel
Front panel
(1 each at left and right)
8
Put down the date of
first use on each part
of the label.
(Composite Air filter and
deodorizing filter)
Rear
Label
¡Hold the clutches
at both sides with
both hands and
pull the front
panel forward.
¡Do not pull a single
clutch firmly by
one side.
Clutch
While the room air is
2
clean, insert the power
plug into a wall socket.
¡The sensors record and set pollution
standard of the indoor air after the power
plug is inserted. (Eliminate odors from
the room as much as possible before
inserting the power plug.)
Power plug
Wall socket
Remove the front panel
3
(see below) and set the
sensor sensitivity level.
Remove the front panel.
Set the sensor sensitivity level.
¡The button should normally adjust to
"Low".
<Sensitivity guide>
• "Low" detects odors from 2, 3 cigarettes.
• "High" detects odors from 1, 2 cigarettes.
Sensor level
Attaching the
front panel
Push
Push
Push
Hole
Tab
Insert the tab at the top of the
front panel into the hole in the
air purifier.
Push the bottom of the front
panel at both sides. (A click
sound will be heard.)
Push the middle of the right
edge of the front panel (in the
place shown by the arrow).

Advertisement

Table of Contents
loading

Table of Contents