Basic Operation; Power Supply; Switching The Device On/Off And Selecting Speed - Silvercrest SKMP 1300 C1 Operating Instructions Manual

__288190_Kuechenmaschine_Profi_B6.book Seite 12 Montag, 7. August 2017 11:09 11
Mounting the lid
NOTES:
• For safety reasons, the blending process
will only start when the lid 2 is correctly
mounted.
• To make it a little easier to close the
lid 2, place a few drops of cooking oil
onto a cloth and rub it over the seal 4.
4. Place the lid 2 slightly distorted onto the
blender jug 5.
5. Rotate the lid 2 clockwise until it stops.
The device is now fully assembled. On work-
ing with the device: see "Basic operation"
on page 12.
12 GB

9. Basic operation

9.1 Power supply

1. Assemble the device for the desired
function.
2. Check that the speed control 11 is set
to 0 (off).
3. Plug the mains plug 13 into a suitable
wall socket. The wall socket must contin-
ue to be easily accessible after the de-
vice is plugged in.
4. Pull out the mains plug before cleaning
the device.
9.2 Switching the device on/
off and selecting speed
WARNING! Risk of material damage!
The mixing mechanism must not be op-
erated continuously for longer than
10 minutes, or the blender for longer
than 3 minutes. You must then allow the
device to cool down to room tempera-
ture.
NOTE: the device only works when either
the cover 8 is mounted (for the mixing tools)
or the lid 2 is correctly mounted on the
blender jug 5.
1. Switch the device on by turning the
speed control 11 to the right.
2. Start at a slightly lower speed, and
slowly increase to the desired speed
(see "Overview of functions" on
page 9).
3. Reduce the speed to setting 1 - 2 when
you are adding ingredients during oper-
ation through the filling opening 20 or
the refill opening 3.
4. Set the speed control 11 to 0 to switch
the device off.