Page 6
ENGLISH Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Your robot (Fig. 1) Top cover Handle of dust container lid Dust container lid Filter Dust container...
Page 7
ENGLISH Cleaning patterns In its auto cleaning mode, the robot uses an automatic sequence of cleaning patterns to clean each area of the room optimally. The cleaning patterns it uses are: Z-pattern or zigzag pattern Random pattern Wall-following pattern Spiral pattern During auto cleaning, the robot uses these patterns in a fixed sequence: Z-pattern (Fig.
Page 8
ENGLISH Preparing the room for a cleaning run Before you start the robot on its cleaning run, make sure that you remove all loose and fragile objects from the floor (Fig. 16). Using your robot Starting and stopping Press the on/off button. Note: Make sure that the robot is no longer connected to a wall socket and that the small plug has been removed from the socket on the robot.
Page 9
Replacement You can order spareparts and accessories at www.shop.philips.com/service or at your Philips dealer. You can also contact the Philips Consumer Care Centre in your country. Replacing the filter Replace the filter if it is very dirty or damaged. You can order a new filter under order number CP0108.
This chapter summarises the most common problems you could encounter with this appliance. If you are unable to solve the problem with the information below, visit www.philips.com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Page 11
If the problem continues to occur on lighter off sensors. This causes the coloured floors, please go to www.philips.com/ robot to move in an support or contact the Consumer Care Centre unusual pattern.