Toro Reelmaster 7000-D Operator's Manual page 15

Figure 19
1. Flange locknut (3/8 inch)
2. Right tab (Carrier frame)
5. Align the holes in the turf-compensator bracket
with the holes in the cutting-unit frame
20).
Note:
The support loop of the hose guide aligns
toward the centerline of the machine.
Figure 20
1. Turf-compensator bracket
2. Carriage bolt (3/8 x 1-1/4
inches)
6. Assemble the turf-compensator bracket to the
cutting-unit frame with the 2 carriage bolts (3/8 x
1-1/4 inches) and 2 flange locknuts (3/8 inch).
7. Torque the locknuts and bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
g375694
3. Capscrew
(Figure
g378789
3. Flange locknut (3/8 inch)
4. Inboard
Installing the Kickstand
For each cutting unit, secure the kickstand to the
chain bracket with the snapper pin
1. Chain bracket
2. Snapper pin
Increasing the Rear Cutting Unit
Pivot Angle
Increase the pivot angle of the rear cutting units by
removing the 2 spacers, 2 hex-socket screws, and 2
flange locknuts (Figure 22
carrier frames of cutting units 2 and 3.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
15
(Figure 21).
Figure 21
3. Cutting-unit kickstand
and Figure 23) from the
Figure 22
5. Cutting unit 5
6. Reel motor
7. Weight
g004144
g367812