2-8-3 Perform test marking
1.
Select "Test marking" in the ribbon.
2.
In the dialog, check the values for the laser settings
and change them if required.
The available parameters depend on the model of
your laser marking system.
3.
Select "Marking time" to perform the measurement.
The marking time is displayed in the dialog.
To exit the dialog, select "OK".
4.
Select "Start marking" to trigger the laser radiation.
A confirmation dialog appears.
5.
Select "Yes" to start laser radiation.
The shutter opens automatically and marking starts.
WARNING
During a marking process, you can select "Stop
marking" to terminate the test marking.
6.
To close the dialog, select "Close".
2
4
3
• Take appropriate protective measures during laser radiation such as wearing
laser protective goggles or using a protective enclosure.
ME-NAVIS2-QR-1
3
35