Sharp JW-20CM User Manual page 143

From the previous page
Set the number of sending bytes of the master station relay link [DCM (decimal), word]
• Set in parameter addresses 005000 to 005001
005000
(8)
005001
(8)
• These top addresses should not overlap the register link area, or the flag area, or exceed the
setting range (0 to 256 bytes for each station, 256 bytes for all stations in total).
In case of setting 8 bytes: Using JW-13PG example for page 9·41
Set the number of sending bytes of the slave station (01 to 77) relay link [DCM (decimal), word]
• Set the number of sending bytes in decimal on the parameter addresses 005002 to 005177
(set in each station, 2 bytes for each station).
These top addresses should not overlap the register link area, or the flag area, or exceed the
setting range (0 to 256 bytes for each station, 256 bytes for all stations in total).
005002
Slave
station 01 005003
(8)
Slave
005176
station 77
(8) 005177
(In case of setting 4 bytes for slave station 01, and set 8 bytes for slave station 02: Example of page
9·41)
Slave station 01
Slave station 02
To the next page
Lower
Upper
Display the contents of parameter addresses 005000 to
005001
(8)
Write 00008 after converting to decimal.
(D)
Lower
｝
(8)
Upper
(8)
to
to
Lower
｝
(8)
Upper
(8)
Write 00004
addresses 005002 to 005003
Write 00008
addresses 005004 to 005005
9 45
·
.
(8)
Enter by decimal
Enter by decimal
in parameter
(D)
.
(8)
in parameter
(D)
.
(8)
Screen display of JW-13PG
05000
05002
I PARAM.
>05004
Screen display of JW-13PG
04774 D 00000
04776 D 00000
I PARAM.
>05000 D 00008
.
(8)
D 00008
D 00004
D 00008
9