(2) Parameter setting by remote function
This paragraph describes how to set the parameters of other stations' network module connected on
the satellite net.
This is only available when the target station is within the standard network connection.
Usable support tools are JW-13PG/12PG.
<An operation example using the JW-13PG>
① Connect the programmer to the network module
Connect the programmer to the network
module on the satellite net.
② Setting mode
Select initial mode.
③ Assign the link
Assign the parameter setting remotely.
→
Select "LINK" in initial.
→
Select display mode of "1PG, 2PG1 MODE" in specified link.
→
Select "TARGET STA." in 1PG, 2PG1 MODE.
④ Setting target station
Select the target station to set the parameter remotely.
→
Change the code from hexadecimal
station (00
⑤ Communication with the target station
→
Initiate communication with the target station.
Display initial mode.
→
to 77
).
(8)
(8)
11
·
display to octal
display and input the target
(H)
(O)
9
11