Sharp JW-20CM User Manual page 197

⑥ Setting parameter
After finishing communication with the target station, set the parameters remotely.
→
Turn the PC of the target station to program mode (stop PC operation).
Select "PARAM." in the initial mode.
<<In case of remote I/O function>>
<<In case of data link function>>
Input address
Input setting value
⑦ Writing to the EEPROM, start operation
After setting the parameter remotely in step ⑥, write 81
at remote I/O function), or at 00777
EEPROM."
11
Return to initial menu.
→
→ Write in 00 , stop operation of the JW-20CM.
(H)
→
→
Write in 00 , stop operation of the JW-20CM.
(H)
→
→
(8)
Display contents of parameter address 003777
Display contents of parameter address 007777
Display contents of address to set the parameters.
Setting parameter remotely.
at parameter address 003777
(H)
(when at data link function), to start the "writing operation to
11 10
·
.
(8)
.
(8)
(when
(8)