Using The Voice Recorder; Switching The Voice Recorder On - Silvercrest KH 2450 Operating Instructions Manual

in battery/cell operation, the battery symbol
Ú
symbol indicate the current full resp. charged condition of the batteries.
in mains power/USB operation the symbol
Ú
The voice recorder is now ready for use.

7. using the voice recorder

7.1 Switching the voice recorder on

1
To switch the voice recorder on: Press the button »ON/OFF«
tus lamp »DICT
logo is briefly shown; indicated subsequently are:
should the batteries/cells have been exchanged before switching on: the battery
Ú
selection screen (see chapter 6 »Preparing the voice recorder for use«, step 3);
the battery selection screen is not indicated if ...
the batteries/cells were not exchanged before switching on
Ú
the switched-off voice recorder is connected to a PC via a USB cable
Ú
(PC operation)
subsequently the SilverCrest logo
Ú
»INT«, should there not be a memory card inserted into the memory card slot
Ú
; in this case the internal memory of the voice recorder is used for dicta-
o
tions.
»EXT«, should there be an SD/MMC memory card inserted into the memory
Ú
card slot ; in this case the memory card is used exclusively as an external
o
memory for dictation recording.
During software loading phases the hourglass symbol in blended in briefly.
Consequently, a short signal tone sounds and the start screen appears with the
following indicators/menu choices:
Should it be that no dictations have yet been saved:
14
« briefly lights up once. In the display
d
; the beams in the battery
.
once. The sta-
a
the SilverCrest
q