Copying Dictation Recording From The Voice Recorder To A Pc - Silvercrest KH 2450 Operating Instructions Manual

the voice recorder for dictation recordings. Additionally, in PC operation you
cannot utilise the menu or any of the other adjustments for the voice recorder.
3
Insert the small plug of the supplied USB cable into the USB interface » «
on the voice recorder.
4
Insert the large plug of the USB cable into a free USB interface on your PC. In
the display
q
blinks. As soon as the charging process begins, the battery symbol fills
and empties itself continually. Should the charging process be interrupted, for
a few seconds a completely charged battery symbol is shown; subsequently it
indicates again the actual charge condition of the inserted batteries.
5
Ensure that the automatic switch-off of the voice recorder is deactivated.
Check this under the Menu item »Power off« (see chapter 8.8 » Switch-off op-
tions«); for charging operations the setting »manual« must be selected. Bear
in mind that the voice recorder in a switched-off condition cannot charge the
batteries in the battery compartment.
6
When the inserted batteries are fully charged, the symbol
the display
q
voice recorder and the USB interface on the PC.

10. Copying dictation recording from the voice recorder to a PC

With the supplied software »Convert« you can copy saved dictation recordings
from the voice recorder to a PC. Thereby, the dictation recordings are converted
into Wave files (data ending.wav), which can be played back with standard com-
mercial media players. The software can be installed and used on PCs complying
with the following minimum requirements:
Pentium III Processor, 500 MHz
Ú
Operating systems ...
Ú
... Windows® 2000
... Windows® XP
... Windows® Vista™
USB 1.1 or 2.0
Ú
60
the symbol
. Remove the USB cable from the USB interface » «
appears briefly; afterwards, the battery symbol
k
is indicated in
on the
k