Connecting Terminating Resistors - Mitsubishi Electric MELSEC Q Series User Manual

4.5.4
Use the CL9-TERM (gray) for the terminating resistors.
For a system configuration using dedicated flat cables only, the CL9-RYVK (black) can also be used.
Note that terminating resistors of the same model must be used for both ends of the trunk line.
(1) Connecting a terminating resistor on the QJ61CL12 side
The following figure illustrates how to connect a terminating resistor.
Connect the terminating resistor within 20cm from the QJ61CL12.
Terminating resistor
(2) Connecting a terminating resistor on the end of the trunk line
The following figure illustrates how to connect a terminating resistor to the opposite end of the QJ61CL12.
Downloaded from ManualsNet.com

Connecting terminating resistors

Within 20cm
search engine
CHAPTER 4 PROCEDURE BEFORE OPERATION
QJ61CL12
Terminating resistor
4
59