Table of Contents
Advertisement
Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
M.2 2230/2280 Solid-state
drive
WLAN card
Power-supply unit
Processor fan and heat-sink
assembly
VR heat sink
SD card reader (optional)
System board
Screw type
M2x3.5
M2x3.5
#6-32
Captive screw
#6-32 (Captive)
#6-32
#6-32
M2x4
6-32
Quantity
1
1
4
4
2
1
1
3
7
Removing and installing components
Screw image
2
11
Advertisement
Table of Contents
