Table of Contents
Advertisement
Intrusion switch
Removing the intrusion switch
Prerequisites
1. Follow the procedure in
before working inside your
computer.
2. Remove the
side
cover.
About this task
The following image indicates the location of the intrusion switch and provides a visual representation of the removal procedure.
Steps
1. Disconnect the intruder cable from the connector on the system board.
2. Slide and remove the intrusion switch from the chassis.
Installing the intrusion switch
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the intrusion switch and provides a visual representation of the installation
procedure.
Removing and installing components
75
Advertisement
Table of Contents
