Silvercrest SKE 3.6 A1 Operating Instructions Manual page 53

Commissioning
1) Take the corkscrew, the charging station
supply device 6 out of the carton and remove all packaging material.
2) Place the cap cutter
station 8.
3) Connect the charge supply device
the barrel plug 4 into the socket on the rear of the charging station 8.
4) Place the charging station
face.
WARNING - RISK OF INJURY!
Do not set the the corkscrew and the charger 8 up in damp environments.
If you do, moisture could penetrate into the corkscrew or the charger 8.
There will then be a risk of electric shock!
5) Insert the charge supply device
power socket.
6) The corkscrew contains batteries that have to be recharged via the charger
Therefore, the corkscrew itself requires no power cable. To charge the cork-
screw, place it in the charger 8.
NOTICE
► When inserting the corkscrew into the charging station
► When the corkscrew is properly inserted in the charger
"Charging" 5 glows. Thereby it is indicated that the corkscrew is inserted
correctly and it is now being charged.
7) Let the corkscrew stand for the 10 hours before using it, so that it becomes fully
charged. After this period, the corkscrew is ready for use.
Electric Corkscrew
8, the cap cutter 7 and the charge
7 into the storage compartment 9 under the charging
6 to the charging station 8 by inserting
8 on a level, scratch-resistant and slip-free sur-
6 to the charging station 8 into a mains
– have its opening facing down,
– have the arrow on the corkscrew pointing to the
marker line on the charging station 8.
8.
8, it must ...
8, the LED
51
GB
IE