Silvercrest SKE 3.6 A1 Operating Instructions Manual page 55

8) Take the corkscrew from the bottle and hold it with the opening down.
press and hold the upper button ▲ 1. The LEDs "In Operation" 3 glow. The
cork is then unscrewed from inside the corkscrew.
9) Release the upper button
10) After use: Place the corkscrew back into the charger
over/fall down.
11) If you do not have to charge the corkscrew: Disconnect the charge supply de-
vice 6 to the charging station 8 from the mains power socket.
Charging
1) When the performance of the corkscrew becomes weaker after repeated use,
it must be recharged. Place the corkscrew in to the charging station 8.
2) When the corkscrew is properly inserted in the charger
ing" 5 glows. Thereby it is indicated that the corkscrew is inserted correctly
and it is now being charged. Leave the corkscrew in the charger 8 for 8-10
hours. This is dependant on how high/low the battery was charged at the
beginning of charging procedure. After this period, the corkscrew is again
ready for use.
WARNING - RISK OF INJURY
To charge the corkscrew, use only the supplied charger station 8 with the
supplied power supply device 6. UNDER NO CIRCUMSTANCES should
you use the charging station 8 to charge other appliances. If you do, the
corkscrew, the charging station 8, the charge supply device 6 and the appli-
ance being charged could be damaged beyond repair. There would then be
the danger of receiving an electric shock and/or causing a fi re!
Electric Corkscrew
▲ 1 as soon as the cork falls off of the corkscrew.
Then
8 so that it cannot fall
8, the LED "Charg-
GB
IE
53