Confirming The Network Status - Panasonic AG-CX10 Operating Instructions Manual

4
Enter each of the network setting items, and then click [Save].
≥ The connection mode of the unit only supports [Fixed IP]. DHCP and other
protocols are not supported. Do not specify these settings.
≥ It may take approximately 2 minutes to complete the setting of the unit after
clicking [Save].
The settings become invalid if the AC adaptor or LAN cable is disconnected
before the settings are complete. Specify the settings again.
@
NOTE
0 The IP address assigned to the unit can be checked by clicking [Search] of EASY IP Setup Software when using the DHCP server.
0 The unit does not support the IPv6 setting due to EASY IP Setup Software.
0 Allow access to all of the ports for UDP when implementing a firewall (including software).
0 Some of the items cannot be set on this unit.
0 [View Camera Screen] displayed on Step 2 and Step 3 does not function on this unit.

Confirming the network status

The network status of the unit can be checked by performing the following operation.
1
Select the [NETWORK] menu → [INFORMATION] → [STATUS].
Chapter 9 Network Connection — Network settings
- 185 -