Panasonic AG-CX10 Operating Instructions Manual page 81

[EXPAND MODE]
Sets the enlargement display function mode.
[10SEC]
[HOLD]
[UNTIL REC]
(Factory setting: [10SEC])
[EXPAND VALUE]
Adjusts the enlargement factor of the enlarged display function.
The items that can be set are as follows.
≥ [×2], [×3], [×4]
(Factory setting: [×2])
[PEAKING LEVEL]
Sets the intensity of the peaking display.
The items that can be set are as follows.
≥ [LOW], [MID], [HIGH]
(Factory setting: [MID])
[PEAKING COLOR]
Sets the color of the peaking display.
The items that can be set are as follows.
≥ [RED], [GREEN], [WHITE]
(Factory setting: [RED])
[DETAIL]
Sets the intensity of the contour for the video to make it easier to focus.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
[DETAIL LEVEL]
Sets the intensity of the contours.
The items that can be set are as follows.
≥ [j3]...[i3]
(Factory setting: [0])
[DETAIL FREQ.]
Adjusts the frequency of the contour highlights.
The items that can be set are as follows.
≥ [HIGH], [LOW]
(Factory setting: [LOW])
[EI ASSIST]
[ZEBRA]
Sets whether to superimpose the zebra signal to the output.
[MOMENT]
[ON]
[OFF]
(Factory setting: [OFF])
[ZEBRA1 DETECT]
Sets the detection level of zebra pattern 1.
The items that can be set are as follows.
≥ [50%]...[105%]
(Factory setting: [80%])
[ZEBRA2 DETECT]
Sets the detection level of zebra pattern 2.
The items that can be set are as follows.
≥ [50%]...[105%]
(Factory setting: [100%])
Chapter 4 Operation — Menu settings
Disables the enlarged display function after 10 seconds have elapsed.
Enables the enlarged display function until either the USER button assigned to [FOCUS ASSIST] is pressed again or the
USER button icon is touched again.
Enables the enlarged display function until performing recording operation.
Press the USER button to which [ZEBRA] is assigned or touch the USER button icon to superimpose the zebra signal for
approximately 5 seconds.
Always superimposes the zebra signal. Press the USER button to which [ZEBRA] is assigned in the [ON] settings or touch the
USER button icon to set to [OFF].
Does not superimpose the zebra signal. Press the USER button to which [ZEBRA] is assigned in the [OFF] settings or touch
the USER button icon to set to [ON].
- 81 -