Rear Drive Cage; Removing The Rear Drive Cage - Dell EMC E39S Series Installation And Service Manual

Figure 95. Installing the SAS expander card
Next steps
1. Connect the SAS cables to the SAS expander card.
2. Install the backplane cover.
3. Install the cooling fan assembly.
4. Install the cooling shroud.
5. Follow the procedure listed in

Rear drive cage

Removing the rear drive cage

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove all the drives.
4. Disconnect all the cables from the rear drive backplane.
Steps
1. Using Phillips #2 screwdriver, loosen the screws that secure the drive cage to the system.
2. Pull and hold the screws to lift the drive cage away from the system.
144 Installing and removing system components
After working inside your system
Safety instructions on page 71.
Before working inside your system
on page 72.
on page 72.