Removing The Drive From The Drive Carrier - Dell EMC E39S Series Installation And Service Manual

CAUTION: To prevent data loss, ensure that your operating system supports hot-swap drive installation. See the
documentation supplied with your operating system.
CAUTION: When a replacement hot swappable drive is installed and the system is powered on, the drive automatically
begins to rebuild. Ensure that the replacement drive is blank or contains data that you wish to overwrite. Any data on
the replacement drive is immediately lost after the drive is installed.
1. Follow the safety guidelines listed in
2. If applicable, remove the drive
Steps
1. Press the release button on the front of the drive carrier to open the release handle.
2. Insert the drive carrier into the drive slot and slide until the drive connects with the backplane.
3. Close the drive carrier release handle to lock the drive in place.
Figure 27. Installing a drive carrier
Next steps
If applicable, install the front

Removing the drive from the drive carrier

Prerequisites
Follow the safety guidelines listed in
CAUTION: Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2. Lift the drive out of the drive carrier.
Safety instructions
blank.
bezel.
Safety instructions
on page 71.
on page 71.
Installing and removing system components 79