Table of Contents
Advertisement
CaptureMat FUNCTION
A printed image (paper or sticker), as stamped page
or an original hand-drawn illustration can be
captured and its outline can be cut out or drawn.
This is useful for capturing images for paper crafts,
then cutting them out.
Note
• Connect the machine and computer with
Wireless Mode to use this function.
Tutorial 2 - Cutting Photographed
Material
■ Preparation
a
Prepare the material and a camera.
When using "CaptureMat" function, prepare the
following types of material.
• Patterns that are clearly drawn, with no gradation,
fading or blurriness
• Not using an extremely intricate design
b
Press
to turn on the machine.
• For details, see "Turning On/Off the Machine" on
page 6.
c
Install the cutting blade holder into the carriage
of the machine.
• For details, see "Installing and Uninstalling the
Holder" on page 34.
48
■ Photographing Material and
Importing the Data
Registering the Calibration Data of the
Camera Used for Photographing
Data for adjusting the distortion, etc., of the
camera used for photographing must first be
registered with DesignNCut Manager.
a
b
a
Click [CaptureMat].
A window appears, allowing you to register
photos and the camera to be used.
Memo
• With the mobile device version: Tap
[CaptureMat], and then go to step
photograph the calibration sheet.
b
Select [New Camera...] from the [Camera]
drop-down list.
The window for registering calibration data
appears.
c
d
e
f
c
to
Advertisement
Table of Contents
