Brother DC200 Operation Manual page 66

Error Code
(Cutting Error Messages (DesignNCut Manager)
Machine)
E552 Failed to load the captured image.
E553 Failed to save the captured image.
DesignNCut machine is not connected to
your device.
E560
Click on "Connect" to connect your
DesignNCut machine.
DesignNCut machine is not connected to
your device.
Please check if DesignNCut and your
E561 computer is connected with USB cable. If
you connect by Wireless LAN, please click
"Change the connection method" and
change connection method.
DesignNCut machine is not connected to
E562 your device. Retry the connection and refer
to the Connection Guide for instructions.
Causes / Solutions
The selected photo cannot be used.
Select an image photographed under the specified
conditions.
The camera may be set so that photographed images are
not saved. Check the camera's settings.
If the camera settings are correct, delete some
unnecessary files since there may be no space available.
The network connection has not been completed yet.
Click [Connect] on the screen to make the connection.
- Check that the machine and computer are connected with
a USB cable.
- Check that the machine is in USB mode.
For details, see "Direct PC Connection Using USB Cable
(Windows Only)" on page 18.
You tried to connect the machine to your device without
the necessary procedures.
Make the connection again referring to the Connection
Guide or "CONNECTING THE MACHINE AND
COMPUTER" on page 12.
4
65