Installation; Required Tools And Consumables - Siemens 667/HB/47750/000 General Handbook

9 Installation

WARNING: Ensure all power sources are switched off and safely isolated
before installation commences. All switches and MCBs should be in the OFF or
BYPASS position.
The UPS solution's modular sections have been designed with ease of installation in
mind. Much of the solution comes prewired with simple plug and play interconnects
between modules. The table below lists the steps required for installation of both the UPS
cabinet and the Battery Expansion Cabinet.
Step No.
1
2
3
4
5 Mount and connect the UPS
6
7 Terminate External cables into
the UPS Connection panel
8
9 Terminate and connect the
10
11 Connect the Batt. Temp.
Table 9-1: Installation Steps for the UPS and Battery Expansion Cabinets

9.1 Required Tools and Consumables

·
14mm socket/spanner
·
10mm socket/spanner
·
10mm insulated spanner
·
5mm Alan key
·
Terminal Screwdriver
·
Cross-head screw driver
·
RJ45 Crimp Tool
·
Cable Ties
·
Gorilla Tape
4
Or similarly industrial self-adhesive tape. Insulation or Electrical tape is not acceptable.
Version 7
Last Editor Ore Oluwatudimu
Document UPS Solution General Handbook
Name
Copyright ã Siemens plc 2017 All Rights Reserved
UPS Cabinet
Prepare and install the Reinforced Stool
Pull and gland ducted cables
Fit the Vented Cabinet Outer Case and seal the base
Fit and connect the Battery Housing module(s)
housing module
N/A
N/A
Ethernet Cable
Fit and connect the batteries
sensor
4
Page 28 of 76
TS008468
Infrastructure and Mobility, Traffic Solutions
Battery Expansion Cabinet
N/A
Mount and connect the DC
Housing module
N/A
Terminate External Cables into
the DC Connection Panel
N/A
N/A
Status
Date
Doc. No.
Sopers Lane, Poole, Dorset
BH17 7ER
Refer to
Section 9.2
Section 9.3
Section 9.4
Section 9.5
Section 9.6
Section 9.7
Section 9.8
Section 9.9
Section 9.10
Section 9.11
Section 9.12
ISSUED
31/01/2017
667/HB/47750/000