Table of Contents
Advertisement
2. Working from back to front, gland these SWA cables to the CET plate, using the
holes and notches provided, in the following order:
o
o
o
o
o
NOTE: Leave enough slack on all cables for termination at the top of the
cabinet. Cables should extend a minimum of 1500mm from the glanding point.
NOTE: When fitting the Battery Expansion Cable, terminate the Green/Yellow
core to the main earth stud on the CET plate.
9.4 Fitting the Vented Cabinet Outer Case and Sealing the Base
Step No.
3
The Vented Cabinet Outer Case is simply a modified ST900 style controller cabinet and
is fitted to the stool in exactly the same way.
NOTE: The Vented Cabinet is packaged with the fixings necessary for fitting
the solutions housing modules (Battery, DC and UPS). Retain fixings until
reaching the appropriate installation step.
1. Fit the Vented cabinet outer case to the reinforced stool using the appropriate
M10 fixings as with the ST900 cabinet outer cases. Refer to 667/HE/45950/000.
2. The cabinet base should now be sealed. See 667/HE/45950/000 for details.
NOTE: Further installation from this point may involve work above un-cured
base seal. It is therefore recommended to mask the openings stool top with
cardboard or similar to prevent the loss of dropped fixings.
Version
7
Last Editor
Ore Oluwatudimu
Document
UPS Solution General Handbook
Name
Copyright ã Siemens plc 2017 All Rights Reserved
Figure 9-3: Reinforced Stool – LEFT HAND SIDE VIEW
UPS Fault / Alarm relay contact cable (if required)
Battery Expansion 54Vdc cable (if required)
Controller 230Vac feed cable
DNO 230Vac supply cable
Ethernet cable (if required)
UPS Cabinet
Fit the Vented Cabinet Outer Case and seal the base
Page 31 of 76
TS008468
Infrastructure and Mobility, Traffic Solutions
Battery Expansion Cabinet
Status
ISSUED
Date
31/01/2017
Doc. No.
667/HB/47750/000
Sopers Lane, Poole, Dorset
BH17 7ER
Refer to
Section 9.4
Advertisement
Table of Contents
