Fujitsu FD-1000AT User Manual page 15

Installation Method 3
1. Remove the ten screws that secure the rear top panel in place.
2. Remove the four screws from the left and right sides of the 4-port KVM switch.
Insert the 4-port KVM switch under the KVM holder between the two bent down flaps
of the rear top panel, making sure that the 4-port KVM switch's will face out from the
rear of the Console Drawer. Fasten it in place with the four screws removed in step 2.
3. Reattach the rear top panel with 4-port KVM switch attached to the rear plate Comp
using the ten screws removed in step 1.
Installation Method 3: 4-port KVM switch Assembly Diagram
Rear top panel must be removed, but no extra screws are
needed.
Remove the Console Drawer from the rack guide rails by
reversing the [Installing Console Drawer] operation on page 7.
(viewed from the left rear)
1 1