Table of Contents
Advertisement
1
Overview
Note
The RAID configuration is established for you without your intervention, so there shouldn't
be any need for you to use these boot manager commands.
For more information about the boot manager, see the Boot Manager Reference Guide.
Note
The IP2450 flash-based appliances do not support RAID-1.
For more information about RAID-1, including configuration details, see Implementing Disk
Mirroring or RAID on a Network Security Appliance, which is available at the Check Point
Support Center at http://support.checkpoint.com/.
Hard-Disk Drive Hot Swap Feature
For any active or RAID-1 synchronized hard-disk drive, you must use the hot swap button,
shown in
down. If you replace or remove drives with the IP2450 shut off, the RAID firmware will lose
track of RAID volume data. For information about how to remove and replace a hard-disk drive,
see
"Installing or Replacing Hard-Disk Drives"
Hard-Disk Drive LEDs
The hard-disk drive LEDs are located on the front panel of each hard-disk drive, as shown in
Figure
4. The LEDs provide the status of the hard-disk drives as described in
Figure 4 Hard-Disk Drive Front Pane
l
Caution
To avoid damage to the ejector and locking lever, loosen the two retaining screws
before you remove the hard-disk drive. Once screw is located behind the ejector and
locking lever, and the other screw is on the opposite side.
22
Figure
4, before you remove or replace a hard-disk drive without shutting the appliance
HARD DRIVE
STATUS
ACTIVITY
Hard-disk drive LEDs
on page 88.
POWER
HOT SWAP
READY
REQUEST
Hot swap button
Check Point IP2450 Security Platform Installation Guide
Table
4.
00621
Advertisement
Table of Contents
