Nokia Check Point IP2450 Installation Manual page 53

12. Insert the new NIC or a blank bezel by doing one of the following:
a. Being careful to push down only where the motherboard connectors are located, press the
b. If you are not replacing a NIC you are removing, insert a blank bezel into the location
Note
To reduce electromagnetic interference (EMI), a blank bezel needs to be installed in the
place of any NIC you have removed.
13. From the top of the 6U PMC carrier, screw the NIC retaining screws into the standoffs on
the back of the NIC.
Check Point IP2450 Security Platform Installation Guide
back end of the NIC down into the connectors until it is fully seated.
formerly occupied by the NIC.
Make sure that the bezel is completely seated onto the slot on the front of the 6U PMC
carrier and that the screw holes on the bottom of the bezel align with those on the bottom
of the PMC carrier. Proceed to
Removing, Installing, and Replacing NICs and ADP Modules
step 14.
00314.1
00312
53