Table of Contents
Advertisement
4. OPERATING PROCEDURES
The uni1 outputs the set values d i s p l a y e d on the v a r i o u s port ions of the
d i s p l a y v i a the RF output t e r m i n a l .
MODULATION, FREQUENCY and LEVEL.
described below.
4-1
FREQUENCY SETTING
4-1-1
NORMAL SETTING
Enter the value by using the CURSOR key ( § ) and rotary encoder ® .
1)
When the ^ ^ or • • key i s pressed, the cursor that 1 i g h t s i n the
upper portion of the display s h i f t s between the MODULATION, FREQUENCY
and LEVEL p o r t i o n s .
frequency d i g i t s are displayed.
2)
Press the ^ or • key to move the cursor to the d i g i t you want to s e t .
3)
When the r o t a r y encoder i s rotated, the d i g i t under the cursor s t a r t s
changing.
Set to desired value.
4)
Repeat steps 2) and 3) unti1 the desired frequency i s set.
* 11 i s not p o s s i b l e to enter a value that i s outside the rated frequency
range of the unit (10kHz~260MHz).
4-1-2
DIRECT SETTING
The set value i s entered by using the FREQ (MHz) key ® , the numeric keys @,
and the ENT key ® or the kHz key ® .
1)
When the FREQ key ®
display are erased and the ENT key' s LED flashes.
The d i s p l a y c o n s i s t s of 3 port i o n s :
How to set the various display portions i s
Move t h e c u r s o r
to t h e p o r t i o n where t h e
i s pressed, the d i g i t s shown on the frequency
17
Advertisement
Table of Contents
