Table of Contents
Advertisement
frequency.
The
step v a l u e set t ing range i s 0.1 kHz — 50MHz.
overstepped, the display changes to frequency display and the step value
returns to the value v a l i d before the new input.
I f n e i t h e r the ENT key nor kHz key i s
been input and whi1e the LED is flashing, the value shown on the display
returns to the frequency value displayed before the step value was input
when the FREQ (MHz) key ®
5)
When the ENT key or kHz key is pressed, the value of the frequency
display changes from step value to frequency
is output.
6)
When the STEP (FREQ) key ®
or d e c r e a s e s
frequency value i s output.
4-2
OUTPUT LEVEL SETTING
4-2-1
NORMAL SETT ING
As in the case of frequency sett ing, the CURSOR key ® and the rotary encoder
©
are used to enter the set value.
1)
P r e s s the A A
port ion.
2)
Press the *4 or • key to move the cursor to the d i g i t you want to s e t .
3)
When the r o t a r y encoder i s rotated, the d i g i t under the cursor s t a r t s
changing.
4)
Repeat steps 2) and 3) unti1 the desired output level value i s s e t .
5)
Level units are e i t h e r EMF dB/z or dBm. Select either one by using the
unit selector switch © .
20
i s pressed again.
i s pressed, the frequency display increases
I n a c c o r d a n c e w i t h t h e set s t e p
or • •
key to move the cursor to the LEVEL d i s p l a y
Set to desired value.
I f t h i s range i s
pressed after the
frequency has
i n d i c a t i o n and t h i s value
i n t e r v a l and t h e
Advertisement
Table of Contents
