Kenwood SG-5260 Instruction Manual page 18

2) While the LED i s f lashing, enter the desired frequency value by using
the numeric keys.
to erase the d i g i t s one by one s t a r t i n g from the l a s t input.
enter the correct value.
3) S e l e c t the frequency
frequency
becomes MHz.
becomes kHz.
* During d i r e c t sett ing, do not press the keys other than the numeric keys
on the front panel.
* I f neither the ENT key nor kHz key i s pressed a f t e r the frequency has been
input and while the LED i s f l a s h i n g , the set value returns to the value
v a l i d before the input when the FREQ (MHz) key ©
a frequency
value also returns to the value v a l i d before the input.
| NOTE
B o t h i n c a s e
resolution i s 0. 1kHz.
18
I f a wrong d i g i t i s entered, press the BS key ( § )
u n i t .
has been i n p u t , and whi1e the LED i s f l a s h i n g , the u n i t
I f the kHz key i s pressed instead of the ENT key, the unit
that exceeds the r a t i n g s of t h i s u n i t i s entered, the set
of norma 1 s e t t i n g and d i r e c t
I f the ENT key i s p r e s s e d
i s pressed again. I f
s e t t i n g ,
Then
a f t e r the
1
s e t t i n g