Table of Contents
Advertisement
frequency.
The
s t e p v a l u e s e t t i n g range I s 1 k H z — 50MHz.
overstepped, the display changes to frequency display and the step value
returns to the value v a l i d before the new Input.
I f neither the ENT key nor kHz key i s pressed a f t e r the frequency has
been input and whI1e the LED i s flashing, the value shown on the display
returns to the frequency value displayed before the step value was input
when the FREQ (MHz) key ©
5)
When the ENT key or kHz key i s pressed, the v a l u e of the frequency
display changes from step value to frequency
i s output.
6)
When the STEP (FREQ) key @
or d e c r e a s e s
frequency value i s output.
4-2
OUTPUT LEVEL SETTING
4-2-1
NORMAL SETTING
As in the case of frequency setting, the CURSOR key © and the rotary encoder
©
are used to enter the set value.
P r e s s the A A or • • key to move the c u r s o r to the LEVEL d i s p l a y
1)
portion.
Press the A or • key to move the cursor to the d i g i t you want to s e t .
2)
3)
When the r o t a r y encoder i s rotated, the d i g i t under the cursor s t a r t s
changing.
4)
Repeat steps 2) and 3) u n t i l the desired output level value i s s e t .
5)
Level units are either EMF dB// or dBm. Select either one by using the
unit selector switch @.
22
i s pressed again.
i s pressed, the frequency display increases
i n a c c o r d a n c e w i t h t h e s e t s t e p
Set to desired value.
I f t h i s range i s
i n d i c a t i o n and t h i s value
i n t e r v a l and t h e
Advertisement
Table of Contents
