Table of Contents
Advertisement
4-3-1-1 Normal Setting
As in the case of frequency setting, the CURSOR key @ and rotaty encoder @
are used to input the set value.
1)
P r e s s the ^ <4 or • •
display portion.
2)
Press the ^ or • key to move the cursor to the d i g i t you want to set.
3)
When the r o t a r y encoder i s r o t a t e d , the d i g i t under the c u r s o r
s t a r t s changing.
4)
Repeat steps 2) and 3) unti 1 the desired modulation value i s set.
* Input values exceeding the FM MODULATION r a t i n g s ( 0 — 100kHz) cannot
be set.
4-3-1-2
The value can be set by using the M O D (kHz, % ) key © , the numeric keys ©
and the ENT key @.
1)
When t h e MOD key ©
MODULATION display and the ENT key s LED flashes.
2)
While the ENT key's LED i s flashing, use the numeric keys to enter the
desired modulat ion value.
key ®
Then enter, then correct value.
3)
When the modulat ion value has been input, press the ENT key.
ENT key i s pressed, the output level value displayed on the display i s
set.
* I f a modulat ion set value exceeding the range of the u n i t ' s rat ings i s
entered, the modulat ion d i s p l a y value w i l l r e t u r n to the modulat ion
value v a l i d before the input.
26
Set to desired value.
Direct Setting
to erase the d i g i t s one by one s t a r t i n g from the l a s t input.
key to move the c u r s o r to the MODULATION
i s p r e s s e d ,
d i g i t s
I f a wrong d i g i t i s entered, press the BS
a r e e r a s e d
from t h e
When the
Advertisement
Table of Contents
