Table of Contents
Advertisement
* I f you want to s e t the address I n d e p e n d e n t l y of the BIGIN and END
addresses, enter the figure by using the direct setting method.
* When the address rotation function i s not used, set the BIGIN address to
00 and the end address to 99.
* When you want to change the address r o t a t ion range, i t i s not p o s s i b l e
to set the BIGIN address higher than the set END address value.
i s i t possible to set the END address lower than the set BIGIN address.
In these cases, use the following procedure.
1)
When s e t t ing the BIGIN address higher than the END address, f i r s t
set
a new END address.
2)
When setting the END address lower than the BIGIN address, f i r s t set a
new BIGIN address.
4-6-3
SECOND FUNCTIONS
The funct ions indicated in red under or next to the keys on the front panel
operates when the 2nd F key ®
act ivated.
"Explanation of the Front Panel" and Sect ion 4 "Operat ing procedures".
4-6-4
SPECIAL FUNCTION OF STO KEY
When the STO key @
of the rear panel's RANGE OUTPUT terminal can be altered.
When the c a r r i e r frequency displayed on the FREQUENCY display i s 35--1, the
output in the range above 35MHz becomes +5V*
0V.
When the c a r r i e r frequency displayed on the FREQUENCY display i s 35--0,
the
output
the
output becomes +5V.
Whenever the STO key and numeric key "3" a r e pressed, the 35 — 1 and 3 5 - -0
d i s p l a y s a l t e r n a t e .
key ©
to s e t .
34
Then set the new BIGIN address.
Then set the new END address.
For d e t a i I s on each of the second funct ions, r e f e r to Sect ion 3
i s pressed followed by the numeric key "3", the output
i n the range above 35MHz becomes 0V.
When the necessary l o g i c i s d i s p l a y e d , press the ENT
i s pressed and the second funct ion mode i s
Below 35MHz the output becomes
I n the range below 35MHz
Neither
Advertisement
Table of Contents
