Table of Contents
Advertisement
F i g . 6 When the tab (FUSE PULL) has been pulled and the fuse removed
5-2
VOLTAGE CHANGE
The voltage of t h i s unit i s set to AC 100V when shipped from the f a c t o r y .
Fo1 low the procedure d e s c r i b e d below when the vo11age s e t t i n g has to be
changed.
1)
Remove the fuse by following steps 1) and 2) i n the preceeding Section 5
-1 "Fuse Replacement". ( I f the fuse i s not removed, changing the voltage
s e t t i n g i s impossible. )
2)
When the fuse i s removed, a p r i n t sheet as the one shown i n F i g . 7 i s
seen inserted under the c l i p .
The current s e t t ing i s 100V.
so "100" i s v i s i b l e .
i n s e r t e d
indicated.
3)
I n s e r t the p r i n t sheet so the d i g i t s i n d i c a t i n g the a l t e r e d
are v i s i b l e . ( F i g . 8)
Securely insert the print sheet as far as i t wi11 go.
Take out this print sheet.
Accordingly, the p r i n t sheet has been
On the b a c k s i d e ,
"120V, 240V" i s
voltage
37
Advertisement
Table of Contents
