Kenwood SG-5110 Instruction Manual page 19

2) While the LED i s f l a s h i n g , enter the desired frequency value by using
the numeric keys.
to erase the d i g i t s one by one s t a r t ing from the l a s t input.
enter the correct value.
3) S e l e c t the f r e q u e n c y u n i t .
frequency has been i n p u t , and w h i l e the LED i s f l a s h i n g , the u n i t
becomes MHz.
becomes kHz.
* During direct sett ing, keys other than the numeric keys on the front panel
do not funct ion.
* I f neither the ENT key nor kHz key i s pressed a f t e r the frequency has been
input and whi1e the LED i s f l a s h i n g , the set value returns to the value
v a l i d before the input when the FREQ (MHz) key ©
a frequency that exceeds the r a t ings of t h i s uni t i s entered, the set
value also returns to the value v a l i d before the input.
I
NOTE
B o t h i n c a s e
resolution i s 100 Hz up to 34. 9999MHz, and 1 kHz above 35MHz.
20
I f a wrong d i g i t i s entered, press the BS key @
I f the ENT key I s p r e s s e d
I f the kHz key i s pressed instead of the ENT key, the unit
of normal s e t t i n g
i s pressed again. I f
and d i r e c t s e t t i n g ,
Then
a f t e r the
1
:
s e t t i n g