Table of Contents
Advertisement
4-3-2
FM-STEREO MODULATION SETTING
Carry out the following preparations prior to the s e t t i n g .
1)
Press the STEREO key ©
previous s e t t i n g , the LED may not 1ight a f t e r the f i r s t pressing. I n
t h i s case, press the key again. )
2)
When t h e STEREO key' s LED l i g h t s ,
modulation mode.
(LED) l i g h t s up.
When the STEREO key i s pressed once more whi1e the key's LED 1ights, the
STEREO key's LED goes out and the mode becomes FM modulat ion mode.
3)
Select the modulat ion source.
To input an e x t e r n a l modulat ion s i g n a l , press the EXT key @.
the i n t e r n a l modulat ion s i g n a l , press e i t h e r the 1 kHz key ©
400Hz key ® .
4-3-2-1
Normal Setting
Use the same procedure as for FM modulation s e t t i n g .
Refer to Section 4-3-1-1.
4-3-2-2
Direct Setting
Use the same procedure as for FM modulat ion sett ing.
Refer to Section 4-3-1-2.
* Whi1e the PILOT key's LED 1ights, the displayed value includes the p i l o t
s i g n a l .
the stereo modulation value i s displayed.
* Input v a l u e s exceeding the STEREO MODULATION r a t i n g s ( 0 — 1 0 5 % )
be set.
up to 99.91
28
u n t i l the key's LED l i g h t s , (Depending on the
In the lower right corner of the MODULATION display "%"
When the PILOT key ®
The s e t t i n g resolution for both normal and direct setting i s 0.1%
t h e mode becomes FM-STEREO
i s pressed to turn OFF the p i l o t s i g n a l ,
To use
or the
cannot
Advertisement
Table of Contents
