Charging - Beko B35010 User Manual

5

Charging

5.1 Charging
Connect the supplied power adapter to the charg-
ing port of the electric scooter. Lithium battery
inside.
• Make sure that the Electric scooter, charger, and
DC power input of the device are always dry.
To charge this Electric scooter,
C
use SOLELY the supplied XHK-
800B-4220 charger with the follow-
ing output: 42 V -2 A.
• Use the mains adapter to plug the DC input of
the device into a conventional socket.
• There will be no light on the charger before
charging, when connected to e-scooter the
adapter will light red, and charging has started.
• The red indicator lights up when properly
charged; if this is not the case, please check
the connections.
• Now you can stop the charging cycle. Over-
charge shortens the battery life.
• The charging process takes up to 4 hours. Do
not charge the battery for more than 3 hours.
After 3 hours, disconnect the charger from the
device and the power supply. Overcharge re-
duces the battery service life.
• Do not remove the device from its package to
fully charge it and then put it back in the pack-
age.
Electric Scooter / User Manual
• Allow the Electric scooter to cool down for at
least 1 hour before it can be put in the package.
• Do not leave the device exposed to sunlight in
a car.
WARNING: When charging, the ma-
A
chine will automatically shut down
and cannot be turned on. It can
be turned on after unplugging the
charger.
A
CAUTION: The Electric scooter must
not be used during the charging cy-
cle
• The LED indicator on the battery charger lights
red during the charging process.
• The LED indicator on the charger will light green
when the charging process is complete.
• After charging, disconnect the charger from the
mains and the Electric scooter.
A
CAUTION: Connect the DC cable
supplied with the Electric scooter
only to the DC input!
• Do not insert foreign objects into the DC input.
CAUTION
• Do not remove the protective cap
from the DC input!
A
• Remove the cap only when charg-
ing the Electric scooter!
• After charging, disconnect the DC
plug and close the DC input again
with the cap!
WARNING: Make sure that neither
water nor other liquids penetrate
A
into the inner components of the
Electric scooter; otherwise, the elec-
tronics/batteries of the device could
be permanently damaged. There is a
risk of injury.
15 / EN