Cleaning And Maintenance; Battery Maintenance; Bearings, Screws, Brakes And Wheels - Beko B35010 User Manual

7

Cleaning and maintenance

• To ensure you get the best possible performance
and experience from your electric scooter, it is
important to do regular maintenance for impor-
tant parts of the product.

• Battery maintenance

• Bearings, Screws, Brakes and Wheels

• Storage and Cleaning
Your electric scooter will require some mainte-
nance so please read and familiarize yourself with
this guide.
7.1 Battery maintenance
• All batteries have a life cycle, and performance
will decrease over time, however here are some
advice to maximize the life span of the battery.
• Make sure that the battery is charged at regu-
lar intervals, even if you do not use the electric
scooter for a long time. This is to prevent dam-
age to the battery, caused by low voltage over
an extended period.
• Avoid draining the battery completely. It is best
to charge while there is still power on it. This will
extend battery life. If the battery is constantly
depleted, it will damage the battery (damaged
battery caused by wrong handling are not cov-
ered by the warranty).
• If riding the electric scooter in cold or very hot
areas, the battery time can be lower than when
riding in temperatures from 15-25° Celsius.
This is not a failure on the batteries, but normal
behavior.
WARNING: Even a fully charged
battery will run out of power if the
electric scooter is not used for a pe-
A
riod. Expect a fully charged battery
to keep power between 90 and 120
days in off mode, before it is fully
discharged. If only partially charged,
this period is lower
20 / EN
• Please make sure the battery does not get
above 50° Celsius, or below minus 10° Celsius
for a longer period. (e.g. don't leave the electric
scooter in a hot car in summer, do not put bat-
tery into fire etc.) Low temperature (e.g. subzero
temperature) can damage the battery cells.
• Keep the Electric scooter away from open flame
or other sources of heat to prevent the battery
from getting too hot. Also make sure not to leave
the electric scooter at freezing temperatures.
Both heat and excessive cold can cause the
battery to discharge.
• Only use original charger or an official replace-
ment, as different batteries may require specific
charger, and if using other chargers, this could
cause damage to the product.
• Do not overcharge and discharge the battery.
• Please make sure to charge the battery before
it is completely out of power, to avoid damaging
the battery cells.
C
Damaged battery caused by wrong
handling are not covered by the war-
ranty.
• It is forbidden to disassemble battery package.
This is only to be handled by official service re-
pair centers and professionals.
7.2 Bearings, screws, brakes and
wheels
Your electric scooter is made up of moving parts,
which in time, will be susceptible to wear and tear.
Bearings and screws: The electric scooter has
sealed and dustproof bearings so that no lubrica-
tion is required. Check the bearings for wear at
regular intervals to avoid unsafe riding. Do not
jump on and off and do not apply excessive force
otherwise to avoid damage to the bearings. This is
not a sports electric scooter.
Electric Scooter / User Manual