Philips 32PFS5709/12 Service Manual page 31

4.4.2 AmbiLight Panel
Refer to Figure 4-32 for details.
1. Gently release the clamps and unplug the two connectors
[1, 2,3] that secure the ambilight panels. Release the clips
3
4.4.3 Small Signal Board (SSB)
Refer to Figure 4-33 for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
2. Unplug all other connectors [2] and the FFC connector [3].
3. Remove all the fixation screws from the SSB [4].
4. The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
Figure 4-33 for details.
4.4.4 Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
Mechanical Instructions
1
Figure 4-32 Rear cover removal [1]
back to
div. table
TPM14.2E LA
from the FFC connector that connect with the AmbiLight
control panel [3].
2. Lift the AmbiLight panel from the rear cover. Make sure that
wires and flat foils are not damaged while lifting the
ambilight panel from the rear cover.
4
1
2
4
Figure 4-33 SSB removal
in damaging the PSU.
1. Gently unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
4. EN 31
2
19610_106.eps
4
3
4
19610_107.eps
2014-Sep-26