Table of Contents
Advertisement
EN 44
4.
TPM14.2E LA
4.9.5
Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.9.6
Keyboard Control unit
1. Unplug the connector from the keyboard control panel.
2. Gently push inwards the two clips at the PSU side of the
unit. Release the unit at the PSU side and turn it away from
the PSU. Now push it towards the PSU to release the
catches at the other side of the unit. Take it out from the
metal bracket.
When defective, replace the whole unit.
4.9.7
Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.9.8
IR/LED Panel
1. Remove the stand bracket, as described earlier.
2. Remove fixation screw that secure the deco rear cover and
take it out from the deco.
3. Unplug the connector from the IR/LED panel.
4. Gently release the double faced adhesive tape that pasted
the panel and take it out from the deco.
When defective, replace the whole unit.
4.9.9
RF4CE module
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the RF4CE module,
gently remove the module from the set.
When defective, replace the whole unit.
4.9.10 WIFI module
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the WIFI module, gently
remove the module from the set.
When defective, replace the whole unit.
4.9.11 LCD Panel
1. Remove the SSB as described earlier.
2. Remove the PSU as described earlier.
3. Remove the keyboard control panel as described earlier.
4. Remove the stand bracket as described earlier.
5. Remove the IR/LED as described earlier.
6. Remove the RF4CE module as earlier.
7. Remove the WIFI module as earlier.
8. Remove the Ambilight module as earlier.
9. Remove the fixations screws that fix the metal clamps to
the front bezel. Take out those clamps.
10. Remove all other metal parts not belonging to the panel.
11. Lift the LCD Panel from the bezel.
When defective, replace the whole unit.
4.10 Assembly/Panel Removal ( for 40"/50"/58"
6809 series)
Instructions below apply to the 50PUS6809/12, but will be
similar for 40"/50"/58" 6800 series models.
4.10.1 Rear Cover
Refer to
Figure 4-47
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
2014-Sep-26
Mechanical Instructions
back to
div. table
1. Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2], [3], [4] that secure the rear cover. Refer to
Figure 4-47
for details.
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
Hide quick links:
Advertisement
Table of Contents
