Table of Contents
Advertisement
4.11.4 Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Gently unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
4.11.5 Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.11.6 Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.11.7 IR/LED Panel
1. Remove the stand bracket, as described earlier.
2. Remove fixation screw that secure the deco rear cover and
take it out from the deco.
3. Unplug the connector from the IR/LED panel.
4. Gently release the double faced adhesive tape that pasted
the panel and take it out from the deco.
When defective, replace the whole unit.
4.11.8 WIFI module
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the WIFI module, gently
remove the module from the set.
When defective, replace the whole unit.
2
2
2
2
1
2
1
2
2
4
3
3
3
Figure 4-54 Rear cover removal
Mechanical Instructions
4.11.9 LCD Panel
1. Remove the rear cover and keyboard unit as described
earlier.
2. Remove the SSB as described earlier.
3. Remove the PSU as described earlier.
4. Remove the Speaker as described earlier.
5. Remove the stand bracket as described earlier.
6. Remove the IR/LED panel as described earlier.
7. Remove the WIFI module as described earlier.
8. Remove the fixations screws that fix the metal clamps to
the front bezel. Take out those clamps.
9. Remove all other metal parts not belonging to the panel.
10. Lift the LCD Panel from the bezel.
When defective, replace the whole unit.
4.12 Assembly/Panel Removal (for 65" 5909 series)
Instructions below apply to the 65PFS5909/12, but will be
similar for other 65" 5909 series models.
4.12.1 Rear Cover and keyboard control panel
Refer to
Figure 4-54
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2], [3], [4] that secure the rear cover. Refer to
Figure 4-54
2. Release the connestors [2,3] and remove all the fixation
screws [1] from the keyboard control panel. Then gently lift
the keyboard from the rear cover. Refer to
details.
3. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
2
2
3
3
back to
div. table
TPM14.2E LA
4.
and
Figure 4-55
for details.
for details.
2
2
2
3
3
4
4
1
1
3
3
EN 49
Figure 4-55
for
M4 × 8
1
M4 × 6
2
2
Q3 × 8
2
3
M3 × 8
4
2
2
19617_108.eps
2014-Sep-26
Hide quick links:
Advertisement
Table of Contents
