Motorola AltiVec MVME5100 Series Installation & Use Manual page 43

PPCBug Firmware
3
3-12
Auto Boot Scan Enable [Y/N]
Y
N
Auto Boot Scan Device Type List = FDISK/CDROM/TAPE/HDISK?
This is the listing of boot devices displayed if the Autoboot Scan
option is enabled. If you modify the list, follow the format shown
above (uppercase letters, using forward slash as separator).
Auto Boot Controller LUN
Refer to the PPCBug Firmware Package User's Manual for a listing
of disk/tape controller modules currently supported by PPCBug.
(Default = 0x00)
Auto Boot Device LUN
Refer to the PPCBug Firmware Package User's Manual listed in
Appendix C, Related Documentation
currently supported by PPCBug.
(Default = 0x00)
Auto Boot Partition Number = 00?
Which disk "partition" is to be booted, as specified in the PowerPC
Reference Platform (PReP) specification. If set to zero, the firmware
will search the partitions in order (1, 2, 3, 4) until it finds the first
"bootable" partition. That is then the partition that will be booted.
Other acceptable values are 1, 2, 3, or 4. In these four cases, the
partition specified will be booted without searching.
= Y?
If Autoboot is enabled, the Autoboot process attempts
to boot from devices specified in the scan list (e.g.,
FDISK/CDROM/TAPE/HDISK
If Autoboot is enabled, the Autoboot process uses the
Controller LUN and Device LUN to boot.
= 00?
= 00?
for a listing of disk/tape devices
Computer Group Literature Center Web Site
). (Default)