Troubleshooting - Philips HR2330 User Manual

9 Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, contact the Consumer Care Center in
your country.
Problem Cause
The power plug is connected
The indicators do not incorrectly.
light up. The power button is not
pressed.
The chamber is assembled
incorrectly.
After pressing the
start/pause button The shaping disc, or the front
the appliance panel is assembled incorrectly.
( )
sounds but it does
The preferred servings is not
not work.
selected.
During processing, the
The front panel knob is
appliance suddenly
loosen.
stop, and then
suddenly restart again.
The safety switch
The ratio of the flour and
of the shaping disc
water is incorrect.
holder is triggered.
During processing, the
The noodle maker is overheat
appliance stops. There
due to long continuous
is no alarm sound or
working time.
flashes.
The mixing paddle can be
The appliance stops blocked by some foreign
during processing, objects.
then the indicators
The dough can be too dry.
are flashing quickly,
and the alarm sounds. The wrong program is
selected.
EN
16
Possible solution
Check whether the power plug is plugged
correctly.
Press the power on/off button
Make sure you follow the user manual to
assemble all parts correctly.
Make sure you have selected the servings
before pressing the start/pause button
Make sure the front panel is securely
assembled.
Follow the flour/water ratio table to measure
the amount of flour and water needed.
Disconnect from the power, and allow the
noodle maker to cool down.
Disconnect from the power, clean the noodle
maker, and follow the user manual again to
restart the noodle making.
.
( )
.
( )