Cabinet Configuration and EMC Booksize
6.1
Information
6.1.1
General
SINAMICS S series components are designed for mounting in an enclosure, for example
because of the required degree of shock protection. Cabinets are the type of enclosure
normally used but other mounting compartments affording protection against shock and
harmful environmental influences may be used. The applicable standard is EN 60439-1.
Low-voltage switchgear and controlgear assemblies
Part 1: Type-tested and partially type-tested low-voltage switchgear assemblies
If the SINAMICS S drive line-up is used for the electrical equipment of machines, the
applicable requirements of EN 60204-1 must also be adhered to.
Safety of machinery
Electrical equipment of machines
Part 1: General requirements
All information for device selection in this section applies to
• Operation in a TN system
• Operating voltage range 3AC 360 V to 3AC 440 V
Booksize Power Sections
Equipment Manual, (GH2), 04.2004 Edition, 6SL3097-2AC00-0BP0
6
6-1