Mitsubishi Electric CAHV-R450YA-HPB Service Manual page 185

[ XI USB Function ]
<3> Necessary Materials
The use of the USB function requires a USB memory stick and a portable battery charger.
See below for the types of USB memory stick and portable charger that can be used.
(1) USB memory stick
Use a USB memory stick that meets the following specifications.
• USB 2.0 compatible
Formatted in FAT 32
•
• Without a security function
(2) Portable battery charger
Use a portable battery charger that meets the following specifications for rewriting the software.
• USB 2.0 compatible
• Voltage and amperage rating of 5 V and 2.1 A (MAX)
• Supports the low current charging mode
A battery charger not compatible with the low current charging mode may turn off while the S/W is being re-write, and
the actions may not be completed successfully.
A LEAD WIRE ASSY USB is required to connect the control board and the portable charger.
Use a cable that meets the following specifications.
[Type A male] - [Male XA connector for the PCB] USB cable. For details of "LEAD WIRE ASSY USB", please contact the
•
sales office.
The connector on the control board side is a female XA connector for the PCB.
HWE22020
- 176 -
GB