Table of Contents
Advertisement
78K0R - Cool it!
3.11 PG-FP4 / QB-MINI2 connector FP1
Connector FP1 (not assembled) allows connecting the PG-FP4 FLASH programmer to 78K0R - Cool it!
board in order to program application software into the 78K0R/KG3 internal flash memory. Please note,
the PG-FP4 FLASH programmer is a separate product from NEC and it is not included in this package.
Additional FP1 allows connecting the QB-MINI2 On-Chip debug emulator to the 78K0R - Cool it! board in
order to use On-Chip debug function of the 78K0R/KG3 device. Please note, QB-MINI2 is a separate
product from NEC and it is not included in this starterkit package.
When using PG-FP4 for FLASH programming or QB-MINI2 for debugging purpose, please configure
switch SW2 of the 78K0R - Cool it! board as following:
SW2
1
2
3
4
5
6
7
8
(*) = individual selectable by user.
FP1
1
GND
2
RESET
3
SI
4
VDD
5
SO
6
N.C.
7
N.C.
8
N.C.
9
N.C.
10
N.C.
11
N.C.
12
N.C.
13
N.C.
14
FLMD0
15
RESET_IN
16
CLK_IN
Table 13: PG-FP4 / QB-MINI2 connector FP1
Setting
OFF
OFF
OFF
ON/OFF
(*)
ON/OFF
(*)
ON
ON
ON
Table 14: Configuration of SW2 when using PG-FP4 or QB-MINI2
User's Manual U18426EE1V0UM00
Signal
Mode
Stand alone and debug mode
Disable On-Board debug function
Disable On-Board debug function
TxD3 connected / disconnected
RxD3 connected / disconnected
L_EVDD applied
L_VDD applied
L_AVREF0 applied
19
Advertisement
Table of Contents
